Endless Pools Pools Spécifications télécharger pdf (Page 10)

Included in the box with the liner are No Diving signs. Please post

these in prominent locations around the pool. The Endless Pool is

hallow and must never be used for diving. Diving into the pool is a

very serious hazard and these stickers are intended to warn children

of the risks. Naturally, adult supervision is also critical whenever chil-

dren use the pool.

12. Water Quality System

Once the water level is three inches below the lowest thru-wall, the

holes must be cut in the liner for the water return and any other

thru-wall penetrations. Please refer to the Supplemental Guides for

the hydrotherapy jets, underwater lights and/or hydraulic treadmill

for instructions specific to those penetrations. Cut a round hole in

the liner using the hole through the steel as a template. Please refer

to the diagram on the next page for proper configuration of the fit-

tings. We have provided two thru-wall fittings; the return fitting has

a male slip x male threaded fitting pre-glued into it. The thru-wall fit-

tings have two rubber gaskets and one cork gasket. One rubber gasket

is placed between the liner and the pool panel. The other rubber gas-

ket is placed between the fitting and the liner inside the pool. The cork

gasket is placed outside the pool under the large hex nut that holds the

fitting to the pool wall. This nut should only be firmly hand tight-

ened. Install the threaded plugs into each of the thru wall fittings to

continue filling the pool.

Fill the pool until the water level is 3 inches below the bottom of the

skimmer opening. Cut the liner with a utility knife using the skimmer

opening in the panel as a template. Punch the ten screw holes with a

phillips head screwdriver. Remove the faceplate, locking rear plate,

and the gasket from the skimmer assembly. Place a small bead of sil-

icone on the backside of the skimmer flange. Place the skimmer gas-

ket on the backside of the skimmer flange making sure that the holes

in the gasket line up with the holes in the flange. Place another bead

of silicone on the backside of the gasket. Position the skimmer into

the opening of the panel making sure to align the holes in the skim-

mer with the holes in the panel. Secure the skimmer to the pool using

the provided screws and locking rear plate. Snap on the skimmer face-

plate. Glue the ball valve assembly onto the bottom of the skimmer so

that the valve handle is facing away from the center of the pool panel.

Make sure to use the PVC cleaner on both faces of the glue joint prior

Position the skimmer into the opening of the panel.

Install one rubber washer between the liner and the pool wall.

Cut the liner using the skimmer opening in the panel as a template.

Water Quality System Components

Inserting the liner in the corner of the liner hanger.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Endless Pools Pools Spécifications Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Piscines hors sol Endless Pools Pools