Endless Pools FastLane Manuel d'utilisateur télécharger pdf (Page 4)

GROUND PREPARATION

The surface the Fastlane Pool is to be assembled on must be firm

and level. The Fastlane Pool must be installed as level as possi-

ble, within 2"- 3" of level (from the highest point to the lowest

point of the pool). If the pool will be assembled on a sloping sur-

face, be sure to install the skimmer on the lower side to ensure that

it will not suck air into the pump. If the ground is not level and it

is desired to make a more level surface, take the earth from the

high area of the uneven surface; do not add earth to the low area

of the surface. Once the surface is level, clear any debris or sharp

objects that may be uncomfortable to walk on or could become a

puncture hazard for the liner. Foam flooring may be added under

the liner for additional comfort.

The pool is comprised of various parts. Therefore, before pro-

ceeding with installation, ensure that all necessary parts for the

pool are present and group like parts together.

Part Description Quantity

(A) Liner 1

(B) Top 130cm straight tubes (wider) 6 (8 for Longer Pool)

(D) Top corner tubes (wider) 4

(E) Bottom corner tubes (thinner) 4

(F) Straight bottom tubes (thinner) 6 (8 for Longer Pools)

(G) Struts 10 (12 for Longer Pools)

The supporting legs, or struts (Part G), support much of the weight

of the Fastlane Pool and may need additional support in “soft

ground” installations, or in areas that may experience excess

ground water. A 2"x 8" x 22" piece of lumber installed under each

strut’s base and leveled with the ground is very effective. Make

sure the entire base of each strut is on the 2" x 8" lumber as any

over-hang may result in bending of the strut. A concrete slab of

the similar dimensions may be used as well. Please note that any

support(s) added under the pool structure must be recessed so that

the top of the support is level with the ground surface. Lifting the

struts or frame in any manner may cause excessive stress on the

liner and frame, and may void the Fastlane Pool warranty. (Refer

to Diagram #1: Supporting Legs / Struts.)

DIAGRAM #1: SUPPORTING LEGS / STRUTS

POOL ASSEMBLY

1. Unfold and spread out liner (Part A) on the prepared area.

NOTE: Keep in mind the desired “swim direction” when

positioning the liner, because when the Fastlane Pool is

fully assembled, the swim direction will be headed towards

the end of the pool that has the pre-cut holes.These holes are

for the water quality thru-wall fittings and hydraulic hoses.

2. Align the struts (Part G) with the prepared cut outs at top

of liner.

3. Connect bottom tubes (Part F) to struts (Part G) one at a time to

make the four sides of the pool. Connect corner tubes (Part E) to

the open ends of both struts to finish each of the four corners.

1 2 3 4 5 6 7 8 9 ... 33 34

Commentaires sur ces manuels

Pas de commentaire

Endless Pools FastLane Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Piscines hors sol Endless Pools FastLane