Endless Pools FastLane Manuel d'utilisateur Page 24

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 34
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 23
23
2) Place the notch cutout piece (saved from Step 7 of Building the
Deck) on the horizontal deck plank at the rear of the pool so
that the outside edge of the piece is flush with the outside edge
of the plank, and the middle of the piece is centered within the
edges of the previously made cutout. Use two of the 2" deck
screws to attach the notch cutout piece to the rear plank, being
careful that the tip of the screw does not touch the pool fabric
and that it does not damage the top rail of the pool frame.
3) Lift the ladder assembly over the decking and into the pool so
that it now straddles the decking along the top rail at the rear
of the pool. Position the ladder in the pool so that the back of
its legs fit into the notch that was cut earlier, and it is pushed
tight against the top rail / plank at the rear of the pool. The two
holes in the ladder platform that are closest to the pool water
should now cover the notch cutout piece that was just attached
to the decking. Using two of the 2" deck screws, secure the lad-
der to the notch cutout piece through these two holes
INSTALLING THE COVER
1) Lay the tracks on each side of the pool so that the opening in
the track is facing towards the water. The track should be flush
with the inside edge of the decking. For the standard length
Fastlane Pool, one length of 7'-4" track needs to be cut down
to 5'-6" for each side of the pool. (For the longer 8 x 17
Fastlane Pool, an additional 7'-4" piece has been included in
the shipment, and needs to be trimmed to two lengths of 2'-2".
In this case, two 7'-4" lengths and a 2'-2" length of cover track
are used on each side of the pool.) When installed, the total
track length should be 12'-10" for a standard Fastlane Pool, and
16'-10" for the longer Fastlane Pool. The inside distance
between the two tracks should be approximately 8'. The fabric
is 8'-6" wide and is designed to rest on the water surface.
Vue de la page 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 33 34

Commentaires sur ces manuels

Pas de commentaire