Endless Pools FastLane Manuel d'utilisateur télécharger pdf (Page 12)

Next, take the 4-1/4” long piece and glue a slip x slip 90º elbow

onto one end. At the other end of this pipe another street elbow

will be glued on, but the 2 faces of the elbows must be aligned.

This can be accomplished by placing both faces of the elbows

onto level ground immediately after the second elbow has been

glued on. This will force the elbows to be facing the same way.

Now take this assembly and glue a heater controller union half

onto the male end of the street elbow. Connect the union half to

the heater controller so that the slip x slip elbow is down and fac-

ing the under the mounting board.

Cut a length of flex PVC from the roll so that when glued into the

slip x slip elbow the opposite end of the pipe is just beyond the

base. Then glue a valve onto the end of that pipe. Finally, use the

flexible pipe to connect the valve to the return fitting union on the

pool.

Cut a 2-1/2” length of flexible PVC and glue that into the suction

fitting on the pump. Glue a valve onto that short piece of pipe.

Then glue a length of PVC between that valve and the suction fit-

ting on the pool.

FASTLANE POOL EQUIPMENT

HUTCH ASSEMBLY

1. Begin by attaching the PVC support (B) to the underside of the

lid (A). Two supports have been provided and are labeled. One

support will be for a 60hz power supply and one support will be

for a 50hz power supply. Choose the support that is appropriate

for your application. If you are unsure which power supply you

have, refer to the specification plate on the motor.

2. Next, assemble the four vertical panels. The textured side of the

panels will be facing out and each panel will be labeled on the

inside face. Panels 1 and 2 have no tabs on the vertical edges

while panels 3 and 4 do. Position the panels so that 1 is oppo-

site 2 and 3 is opposite 4. Align the holes in panels 1 and 2 with

the tabs of 3 and 4. Use the shorter screws to attach the 4 pan-

els together.

3. The underside of the lid will have 1-4 engraved on each side.

Line up the numbers on the underside of the lid with the corre-

sponding vertical panel. Use the longer screws to attach the lid

to the vertical face. Make sure that there is a cylindrical space

between the lid and the vertical face at each screw.

4. Remove the mounting bracket and adhesive protective film of

the heater controller keypad. Feed the keypad cord into the oval

hole in panel 4. Press the keypad firmly against the panel. Feed

the mounting bracket back over the keypad cord and tighten it

against panel 4.

5. Once the Water Quality System is fully assembled, place the

weather guard over the entire power unit so that the opening in

panel 2 is seated around the power unit controller.

6. Align the 3 holes in the bottom of panel 1 with the holes in the

water quality base. Use the short screws to attach the weather

guard to the base.

Panel 1

Panel 3

Panel 4

Panel 2

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Commentaires sur ces manuels

Pas de commentaire

Endless Pools FastLane Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Piscines hors sol Endless Pools FastLane